User's Manual

Tsunami MP.11and MP.11a Installation and Management
Satellite Density
The Satellite Density setting is a valuable feature for achieving maximum bandwidth in a wireless
network. It influences the receive sensitivity of the radio interface. Selections are Large, Medium,
Small, Mini, and Micro. See “Satellite Density” on page 69 for more information.
Registration Timeout
This is the registration process time-out of a satellite on a base. Default is 5 seconds.
Network Secret
A network secret is a secret password given to all nodes of a network. A satellite can only register to
a base if it has the same Network Secret. The Network Secret is sent encrypted and can be used as
a security option. Also see “Network Name.”
Input / Output Bandwidth Limit
These parameters limit the data traffic received on the wireless interface and transmitted to the
wireless interface, respectively. Selections are in steps of 64 Kbps from 64 to 108,032 kbps.
Ethernet
You can set the desired speed and transmission mode from this tab. The recommended setting is
auto-speed-auto-duplex.
To set the Ethernet speed, duplex mode, and input and output bandwidth limits, click the Configure
button, the Interfaces tab, and the Ethernet sub-tab.
Note: Current software always does auto-speed auto-duplex regardless of user selection.
You can set the Configuration parameter:
Select from these settings for the type of Ethernet transmission (Configuration drop-down box):
10 Mbit/s – half-duplex 100 Mbit/s – full-duplex
10 Mbit/s – full-duplex autospeed – half-duplex
10 Mbit/s – auto-duplex autospeed – auto-duplex
100 Mbit/s – half-duplex
Half-duplex means that only one side can transmit at a time.
Full-duplex allows both sides to transmit.
Auto-duplex selects the best transmission mode for the given configuration.
Chapter 5. Web Interface 54
CPN 65755 Issue Date: August 2003