User's Manual

Tsunami MP.11and MP.11a Installation and Management
Full (0 dB)
Half (-3 dB)
Quarter (-6 dB)
Eighth (-9 dB)
Minimum (-10 dB)
Enable Turbo Mode (MP.11a ONLY)
Check this box to enable Turbo Mode. Turbo Mode currently is supported only in the United
States. Turbo Mode utilizes two adjacent channels for wireless data transfer.
Frequency Channel
The frequency channel the MP.11 (802.11b) uses for communicating with remotes. This frequency
channel can be set in the range 1 to 11 for the USA and Canada, or 1 to 13 for Europe, or 1 to 14 for
Japan (see “Radio Specifications” on page 111).
For the MP.11a (802.11a), when DFS is enabled for the selected country, the Frequency Channel
field appears as follows:
Frequency Channel – DFS, Auto selected 5.47 – 5.7 GHz
. You can monitor the DFS scan, if enabled, by refreshing the Web page.
The channels and frequencies scanned when DFS is enabled are listed in the following table.
Output Power Table for ETSI
Frequency Channels 54 Mbps 48 Mbps 36 Mbps 6-24 Mbps
5.47 – 5.70 GHz
100, 104, 108, 112, 116,
120, 124, 128, 132, 136
14.5 15.5 17.4 17.4
For countries in which DFS is not enabled, the Frequency Channel list displays only the channels
and frequencies allowed for the selected country. See “Dynamic Frequency Selection” on page 68
for more information.
Data Rate
The rate at which data is to be transferred. The default data rate for the MP.11 is 11 Mbps; the
default data rate for the MP.11a is 36 Mbps. The SU must never be set to a lower data rate than the
Base Station because timeouts will occur at the Base Station and communication will fail.
Selections for Data Rate are as shown in the following table.
Date Rate Date Rate, Turbo Enabled
6 Mbps
9 Mbps
12 Mbps
18 Mbps
24 Mbps
36 Mbps
48 Mbps
54 Mbps
12 Mbps
18 Mbps
24 Mbps
36 Mbps
48 Mbps
72 Mbps
96 Mbps
108 Mbps
Chapter 5. Web Interface 53
CPN 65755 Issue Date: August 2003