User's Manual

Tsunami MP.11and MP.11a Installation and Management
3) Interfaces
Wireless
To configure the wireless interface, click the Configure button followed by the Interfaces tab; then click
the Wireless sub-tab.
The wireless interface can be placed in either WORP Base or WORP Satellite mode (selected from the
Interface Type drop-down box). (See “Wireless Outdoor Router Protocol” on page 69 for more
information.) The wireless interface settings differ per mode.
You can change the following parameters:
Interface Type
The interface type can be Worp Satellite or Worp Base. *See “Wireless Outdoor Router Protocol”
on page 69.)
Base Station System Name
The name found on the system page of the Base Station to which this satellite is connecting. This
parameter can be used as an added security measure, and when there are multiple Base Stations in
the network and you want a satellite to register with only one when it may actually have adequate
signal strength for either.
If the Base Station System Name is left blank on the satellite, it can register with any Base Station
with a matching Network Name and Network Secret.
Chapter 5. Web Interface 51
CPN 65755 Issue Date: August 2003