Specifications

Configuration Tsunami MP.11 5012/5054-SUI Installation and Management

Network Parameters

DHCP Relay Agent (Routing Mode Only)

NOTE: The unit must be in Routing mode to configure DHCP Relay Agent.

Click Configure > Network > DHCP RA to enable the 5012/5054-SUI DHCP Relay Agent. When enabled, the DHCP

relay agent forwards DHCP requests to the set DHCP server. There must be at least one entry in the corresponding

Server IP Address table in order to enable the DHCP Relay Agent.

Note that DHCP Relay Agent parameters are configurable only in Routing mode. It cannot be enabled when NAT or

DHCP Server is enabled.

Add Entries to the DHCP Relay Agent Table

To add entries to the table of DHCP Relay Agents:

1. Click Add Table Entries; the following window is displayed:

2. Enter the Server IP Address and any optional comments, and click Add.

Edit/Delete Entries in the DHCP Relay Agent Table

To edit or delete entries in the table of DHCP Relay Agents:

1. Click Edit/Delete Table Entries. The following window is displayed: