Specifications

Basic Management Tsunami MP.11 5012/5054-SUI Installation and Management

General Configuration Settings

• System Status: The status tab showing the system status is displayed automatically when you log into the Web

interface. It is also the default window displayed when you click the Status button on the left side of the window. See

Status for more information.

• System Configuration: The System Configuration window lets you change the unit’s country, system name, location

name, and so on (see the window to the right). The Country selection is required to enable the correct radio

parameters. The other details help distinguish this unit from other routers, and let you know whom to contact in case

of problems. See System Parameters for more information.

• IP Configuration: The IP Configuration window lets you change the unit’s IP parameters. These settings differ

between Routing and Bridge mode. See Network Parameters for more information.

• Interface Configuration: The Interface configuration pages let you change the Ethernet and Wireless parameters.

The Wireless tab is displayed by default when you click the Interfaces tab.

• Ethernet: To configure the Ethernet interface, click Configure > Interfaces > Ethernet. You can set the

Configuration parameter from this tab for the type of Ethernet transmission. The recommended setting is

auto-speed auto-duplex. See Ethernet for more information.

• Wireless: To configure the wireless interface, click Configure > Interfaces > Wireless. For BSUs, the wireless

interface can be placed in either WORP Base or WORP Satellite mode (selected from the Interface Type drop-down

box). SUs can be placed only in WORP Satellite mode. (See Interface Parameters for more information.)

• VLAN Configuration: VLANs are configured on the Base Station Unit only. See Virtual Local Area Networks (VLANs)

for an overview of VLAN functionality, and the Tsunami MP.11-R Installation and Management Guide for configuration

information.