Specifications

System Overview Tsunami MP.11 5012/5054-SUI Installation and Management

Basic Configuration Information

Country and Related Settings

The unit’s Configure System window provides a selectable Country field that automatically provides the allowed

bandwidth and frequencies for the selected country/band.

Units sold only in the United States are pre-configured to scan and display only the outdoor frequencies permitted by the

FCC. No other Country can be configured. Units sold outside of the United States support the selection of a Country by

the professional installer.

NOTE: Non-US installers should not add an antenna system until the Country is selected, the unit is rebooted, and the

proper power level is configured. The output power level of the final channel selected by DFS scan can be found

in the Event Log.

The Dynamic Frequency Selection (DFS) feature is enabled automatically when you choose a country and band that

require it. The Transmit Power Control (TPC) feature is always available.

Click Configure > System; then select the appropriate country/band for your regulatory domain from the Country drop-

down box.

Continue configuring settings as desired; then click Commands> Reboot tab to save and activate the settings.

Alternatively, if you want to save the configuration settings to the flash memory but not activate the settings, use the save

config CLI command.

Dynamic Frequency Selection (DFS)

The Tsunami 5012/5054-SUI supports Dynamic Frequency Selection (DFS) for FCC, IC, and ETSI regulatory domains

per FCC Part 15 Rules for U-NII devices, IC RSS-210, and ETSI EN 301-893 and 302-502 regulations, respectively.

These rules and regulations require that 802.11a devices use DFS to prevent interference with radar systems and other

devices that already occupy the 5 GHz band.

During boot-up, the unit scans the available frequency and selects the best channel. If the unit subsequently detects

interference on its channel, it rescans to find a better channel. Upon finding a new channel, the unit is required to wait 60

seconds to ensure that the channel is not busy or occupied by radar, and then commences normal operation. (In Canada,

if the channel was previously blacklisted, the unit scans for 600 seconds before commencing normal operation if the

selected channel frequency is in the 5600 - 5650 MHz range).

If you are using the unit in a country and band that require DFS, keep in mind the following:

• DFS is not a configurable parameter; it is always enabled and cannot be disabled.

• You cannot manually select the device’s operating channel; you must let the unit select the channel. You may make

channels unavailable by manually “blacklisting” them and preventing those channels being selected, in accordance

with local regulations or interference. You can also display the Channel Blacklist Table to view the channels that have

been blacklisted.

• In compliance with FCC regulations, the unit uses ATPC (Automatic Transmit Power Control) to automatically adapt

transmit power when the quality of the link is more than sufficient to maintain a good communication with reduced

transmit power. See Transmit Power Control for more information.

Dynamic Frequency Selection (DFS) is enabled automatically based upon the country and band you select. You can tell

DFS is in use because the Frequency Channel field on the Interfaces page displays only the DFS-selected frequency.

DFS scans all available frequencies, starting with the DFS preferred channel (when configured) and skipping blacklisted

channels, to select the operating frequency automatically.

A country/band selection with DFS enabled causes the Base Station to come up in scan mode. It scans the available

frequencies and channels to avoid radar and selects a channel with the least interference.

NOTE: Scanning is performed only on the frequencies allowed in the regulatory domain of the country/band selected

when it is required for radar detection and avoidance.