Specifications

Installation and Initialization Tsunami MP.11 5012/5054-SUI Installation and Management

Installation Procedure

Step 9: Align the Antenna

Antenna Alignment Display (AAD) provides a measurement of signal quality in an easy-to-interpret manner—a numeric

printed signal value at the CLI. The SNR is numerically displayed on the CLI by two decimal characters representing a

number from 00 to 99.

To start the display, you must enable AAD and a wireless link must be established between the BSU and the SU.

Aiming is complete if moving in any direction results in a falling SNR value.

Antenna Alignment Commands

set aad enable local: Enables display of the local SNR. Local SNR is the SNR measured by the receiver at the

near end.

set aad enable remote: Enables display of the remote SNR. Remote SNR is the SNR as measured by the receiver

at the far end.

set aad enable average: Enables display of the average SNR. The average SNR is the average of the local and

remote SNR.

set aad disable: Disables Antenna Alignment Display (Ctrl-C also disables AAD).

Step 10: Install Documentation and Software

To install the documentation and software on a computer or network:

1. Place the CD in a CD-ROM drive. The installer normally starts automatically. (If the installation program does not start

automatically, click setup.exe on the installation CD.)

2. Click the Install Software and Documentation button and follow the instructions displayed on the installer windows.

The following documentation and software products are installed:

– Available from Start > All Programs > Tsunami > MP.11 [Model Name]:

• Documentation (in Docs subdirectory):

– Installation and Management Guide

– Quick Installation Guide

– Reference Manual

– Safety and Regulatory Guide

– Recommended Antenna Guide

– Antenna Installation Guide

• Online Help

• Scan Tool (in Scan Tool subdirectory)

• TFTP Server (in TFTP Server subdirectory)

NOTE: All of these items are also available from C:\Program Files\Tsunami\MP.11 [Model Name].

– Available from C:\Program Files\Tsunami\MP.11 [Model Name]:

• Documentation (in Docs folder): See list above

• Help files (in Help folder; click on index.htm to access)

• TFTP Server and Scan Tool program (in Extras folder)

•MIBs (in MIBs folder)