Specifications

Installation and Initialization Tsunami MP.11 5012/5054-SUI Installation and Management

Installation Procedure

Step 5: Mount the Unit

The following are the mounting options for the 5012/5054-SUI:

• Wall Mounting

• Ceiling Mounting

Wall Mounting

Follow these steps to mount the unit on a wall:

1. If the unit’s power supply is plugged in, unplug it.

2. Identify the location at which you intend to mount the unit.

3. Put the mounting plate up to the wall so that the embossed letter “L” is on top (see figure). If the plate is correctly

oriented, the circular tab that is vertically aligned with the square hole should be on top.

4. Fasten the mounting plate with two screws through the circular holes of the plate. Depending on the type of wall you

may need to use the two fasteners provided.

5. Holding the 5012/5054-SUI so that the connectors on the rear are facing left, align the two holes on the bottom of the

unit with the two tabs on the mounting plate. Press the unit down so it is flushed with the plate.

6. Carefully slide the unit to your right until the tabs snap securely onto the narrow holes of the unit. If the 5012/5054-SUI

is mounted correctly no portion of the mounting plate should protrude from any of the sides of the unit.

Ceiling Mounting

Follow these steps to mount the 5012/5054-SUI to a ceiling:

1. If the unit’s power supply is plugged in, unplug it.

2. Identify the location at which you intend to mount the unit.

3. Snap the rectangular tabs on the back of the mounting plate onto a ceiling T-bar. You may need to slightly rotate the

plate until it securely snaps onto the T-bar.

4. Fasten the mounting plate to the ceiling tile with two screws through the circular holes of the plate.

5. Position yourself so that the embossed letter “L” on the mounting plate is facing up (see previous figure). Holding the

5012/5054-SUI so that the connectors on the rear are facing to your left, align the two holes on the bottom of the unit

with the two tabs on the mounting plate. Press the unit up so it is flushed with the plate.

6. Carefully slide the unit to your right until the tabs snap securely onto the narrow holes of the unit. If the unit is mounted

correctly no portion of the mounting plate should protrude from any of the sides of the unit.