Specifications

Installation and Initialization Tsunami MP.11 5012/5054-SUI Installation and Management

Installation Procedure

Step 4: Install the Security Cover (Optional)

You can optionally install a security cover to deter unauthorized access to the 5012/5054-SUI. The security cover is a

plastic enclosure that prevents access to the cabling and the Reset and Reload buttons.

1. Open the split end of the security cover just enough to slide the power cable (if not using PoE) and the Ethernet cable

through the opening until they fit inside the straight clamping portion of the cover. Exercise care as you slide the

cable(s) so you do not accidentally break the cover (see figure).

2. Slide the hinging end of the security cover into the hole on the rear panel of the 5012/5054-SUI to the left of the

connectors. Once in place, pivot the right side of the cover to bring it close to the rear panel of the 5012/5054-SUI.

3. Use the two attached screws to fasten the security cover onto the rear panel of the 5012/5054-SUI.