Specifications

Installation and Initialization Tsunami MP.11 5012/5054-SUI Installation and Management

Installation Procedure

Step 3: Attach Cables

Cabling without Power Over Ethernet (PoE)

1. Plug the barrel of the power cable from the power supply into the power jack (the leftmost port in the back of the unit,

see figure).

2. Connect one end of an Ethernet cable (not supplied) to the unit’s LAN port (see figure). The other end of the cable

should not be connected to another device until after installation is complete:

• Use a straight-through Ethernet cable if you intend to connect the 5012/5054-SUI to a switch, hub, or patch panel.

• Use a cross-over Ethernet cable or adapter if you intend to connect the 5012/5054-SUI to a single computer.

3. Continue with Step 4: Install the Security Cover (Optional).

Cabling with Power Over Ethernet (PoE)

1. You must use an Active Ethernet adapter such as the ORiNOCO 1-Port Active Ethernet DC Injector (ordered

separately). Connect one end of an Ethernet cable (not supplied) to the unit’s LAN port. Connect the other end to the

Data and Power Out port of the DC Injector (see figure).

2. Connect one end of a second Ethernet cable (not supplied) to the Data In port of the DC Injector (see figure). The

other end of the cable should not be connected to another device until after installation is complete:

• Use a straight-through Ethernet cable if you intend to connect the 5012/5054-SUI to a switch, hub, or patch panel.

• Use a cross-over Ethernet cable or adapter if you intend to connect the 5012/5054-SUI to a single computer.

3. Continue with Step 4: Install the Security Cover (Optional) below.