Specifications

Configuration MP.11 5054 (MP.11a) Installation and Management
System Parameters
57
You can view or enter the following details:
• System Name: This is the system name for easy identification of the BSU or SU. The System Name field is limited to
a length of 32 bytes. Use the system name of a BSU to configure the Base Station System Name parameter on an SU
if you want the SU to register only with this BSU. If the Base Station System Name is left blank on the SU, it can
register with any Base Station that has a matching Network Name and Network Secret.
• Country: Upon choosing a country/band, the Dynamic Frequency Selection (DFS) and Transmit Power Control (TPC)
features are enabled automatically if required. The Country selection pre-selects and displays only the allowed
frequencies for the selected country/band.
Click Configure > Interfaces > Wireless to see the channel/frequency list for the selected country/band.
NOTE: If All Channels 5 GHz is selected from the Country drop-down menu, any channel in the 5 GHz range are
displayed for manual selection.
NOTE: Units sold only in the United States are pre-configured to scan and display only the outdoor frequencies
permitted by the FCC. No other Country selections, channels, or frequencies can be configured. Units sold
outside of the United States support the selection of a Country by the professional installer. If you change the
Country, a reboot of the unit is necessary for the upgrade to take place.
For a non US-only device, the default country selected is United Kingdom (GB).
Note the following:
– The channel center frequencies are not regulated; only the band edge frequencies are regulated.
– If, before upgrade, US was selected as a country for a non US-Only device (which is an incorrect configuration),
the country is changed automatically to United Kingdom upon upgrade.
See Country Codes and Channels for a list of country codes.
• Location: This field can be used to describe the location of the unit, for example “Main Lobby.”
• Contact Name, Contact Email, and Contact Phone: In these fields, you can enter the details of the person to
contact.
• ObjectID: This read-only field shows the OID of the product name in the MIB.
• Ethernet MAC Address: This read-only field shows the MAC address of the Ethernet interface of the device.
• Descriptor: This read-only field shows the product name and firmware build version.
• Up Time: This read-only field shows the length of time the device has been up and running since the last reboot.