Specifications

Installation and Initialization MP.11 5054 (MP11.a) Installation and Management

Installation Procedure

4. If you have not done so before, attach the metal base as described in Step 3: Attach Base (for Desktop or Ceiling

Mounting only).

5. Feed a mounting screw through each of the four rubber feet. The 5054 comes with four 3.5 mm x 40 mm pan-head

screws.

6. Remove the screws from the rubber feet.

7. With the 5054 turned upside down, position the base against the ceiling where you want to mount the unit.

8. Mark the center of the four mounting holes in the rubber feet.

9. Set the 5054 aside and drill a hole at each of the locations you marked. Each hole should be wide enough to hold a

mounting plug (6 mm x 35 mm).

10. Insert a plug into each hole. The 5054 comes with four 6 mm x 35 mm plugs.

11. Insert the screws into the holes you made previously in the rubber feet.

12. Insert the screws into the mounting plugs.

13. Use a screwdriver to tighten the screws, attaching the 5054’s metal base to the ceiling.

Rubber feet