Specifications

Installation and Initialization MP.11 5054 (MP11.a) Installation and Management

Installation Procedure

Wall Mount

1. Place the back cover on the mounting location and mark the center of the three mounting holes.

2. Remove the cover from the wall and drill a hole at each of the locations you marked. Each hole should be wide

enough to hold a mounting plug (6 mm x 35 mm).

3. Insert a plug into each hole. (Four 6 mm x 35 mm plugs are provided; you need to use only three of these for wall

mounting.)

4. Insert a screw into each of the mounting holes molded into the back cover, and align with the holes on the wall. (Four

3.5 mm x 40 mm pan-head screws are provided; you need to use only three of these for wall mounting.)

5. Use a screwdriver to tighten the screws, attaching the back cover to the wall.

6. Fit the radio inside the back cover, with the serial connection and LED indicators facing out.

7. Replace the front cover, threading the cables through the opening at the lower right side of the cover.

8. Replace the cable cover (figure A), ensuring that the release latch clicks upwards to the closed position (figure B).

Mounting holes