Specifications

Procedures MP.11 5054 (MP.11a) Installation and Management
Hard Reset to Factory Default
156
Hard Reset to Factory Default
If you cannot access the unit’s user interface or you have lost its password, you can reset the unit to the factory default
settings. Resetting to default settings means you must configure the unit anew.
To reset to factory default settings, using the end of a paper clip, press and hold the unit’s RELOAD button for a minimum
of 5 seconds but no more than 10 seconds. The configuration is deleted from the unit and the unit reboots, writing and
using a default configuration.
CAUTION: It you hold the RELOAD button for longer than 20 seconds, you may go into Forced Reload mode, which
erases the unit’s embedded software. This software image must be reloaded through an Ethernet
connection with a TFTP server. The image filename to be downloaded can be configured with either
ScanTool through the Ethernet interface or with the Boot Loader CLI through the serial port to make the unit
functional again.
Reset
Reload