Specifications

Configuration MP.11 5054 (MP.11a) Installation and Management
QoS (Quality of Service) Parameters (BSU Only)
122
• IP Mask or MAC Mask: 255.255.255.255 (for IP Mask) or FF:FF:FF:FF:FF:FF (for MAC mask)
9. Click Add.
10. Return to the QoS PIR tab, and click Add Table Entries.
11. Now you will configure the Source Address PIR. Enter the Rule Name:
Enter the Rule Name: Management Station SRC MAC Addr if you are using a MAC addresses, or Management
Station SRC IP Addr if you are using a IP addresses.
12. Set the Entry Status to Enable.
13. Click Add. The SRC Management PIR will be added to the PIR list.
14. Click the Details button next to the SRC Management PIR you just created.
15. Scroll down to the Source IP Table or the Source MAC Table, depending on your configuration requirements,
and click Add Table Entries.
16. Enter the following information:
• IP Address or MAC Address: IP address or MAC Address of management station
• IP Mask or MAC Mask: 255.255.255.255 (for IP Mask) or FF:FF:FF:FF:FF:FF (for MAC mask)
17. Click Add.
Step 2: Add Service Flow Classes
To handle management traffic, the system needs two Service Flow Classes: one for uplink traffic, and one for downlink
traffic.
A. Configure the Downlink Service Flow
1. Click Configure > QoS > QoS SF Class.
2. Click Add Table Entries.
3. Enter the following parameters:
• SF Name: DL-Management
• SF Schd Type: RtPS
• SF Direction: Downlink
• MIR: 1000
• CIR: 1000
• Latency: 20
• Jitter: 10
• Priority: 7
• Number of Frames Per Burst: 4
• SF Entry State: Enable
4. Click Add. The DL-Management SF will be added to the QoS Service Flow Table.
B. Configure the Uplink Service Flow
1. Remaining on the Service Flow Entry Add page, enter the following parameters:
• SF Name: UL-Management
• SF Schd Type: RtPS
• SF Direction: Uplink
• MIR: 1000
• CIR: 1000
• Latency: 20
• Jitter: 10