Specifications

Introduction MP.11 5054 (MP.11a) Installation and Management

Wireless Network Topologies

The unit can be used in various network topologies and combinations. The required equipment depends upon the

wireless network topology you want to build. Make sure all required equipment is available before installing the unit.

You can connect the 5054 to an outdoor antenna with an optional antenna kit. See the Tsunami MP.11 Antenna

Installation Guide for details.

WARNING: To connect the unit to an outdoor antenna, consult the appropriate manufacturers’ documentation

for additional regulatory information, safety instructions, and installation requirements.

You can set up the following types of topologies:

• Point-to-Point Link

• Point-to-Multipoint Network

Each unit is set up as either a Base Station Unit (BSU) or a Subscriber Unit (SU). A link between two locations always

consists of a BSU and an SU. A BSU can, depending upon its configuration, connect to one or more SUs. An SU,

however, can connect to only one BSU at a time.

Point-to-Point Link

With a BSU and an SU, it is easy to set up a wireless point-to-point link as depicted in the following figure.

A point-to-point link lets you set up a connection between two locations as an alternative to:

• Leased lines in building-to-building connections

• Wired Ethernet backbones between wireless access points in difficult-to-wire environments