User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 117
2) Upload a Configuration File
Click the Commands button and the Upload tab to upload a configuration file from the unit. Enter Server IP
Address, File Name, select a Filetype, and click OK.
Filetype can be configured as Templog, Eventlog, or Config.
3) Reboot the Device
Click the Commands button and the Reboot tab to restart the unit’s embedded software. Configuration changes
are saved and the unit is reset.
CAUTION: Rebooting the unit causes all users currently connected to lose their connection to the
network until the unit has completed the restart process and resumed operation.
4) Reset the Device
Click the Commands button and the Reset tab to restore the configuration of the unit to the factory default
values.
You can also reset the unit by disconnecting and reconnecting the unit’s power. Because this resets the unit’s
current IP address, a new IP address must be assigned.
CAUTION: Resetting the unit to its factory default configuration permanently overwrites all changes
made to the unit. The unit reboots automatically after this command has been issued.