User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 113
7) View IP and MAC Address Mapping
Click the Monitor button and the IP ARP Table tab to view the mapping of the IP and MAC addresses of all units
registered at the BSU. This information is based upon the Address Resolution Protocol (ARP).
8) View Active IP Routes
Click the Monitor button and the IP Routes tab to view all active IP routes of the unit. These can be either static
or dynamic (obtained through RIP). This tab is available only in Routing mode, and you can add routes only
when in Routing mode.
9) View All Detected MAC Addresses (Learn Table)
Click the Monitor button and the Learn Table tab to view all MAC addresses the unit has detected on an
interface. The Learn Table displays information relating to network bridging. It reports the MAC address for each
node that the device has learned is on the network and the interface on which the node was detected. There can
be up to 10,000 entries in the Learn Table. This tab is only available in Bridge mode.