User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 111
Note: A Base Station shows how many WORP SUs it can support; the Subscriber Unit and Residential
Subscriber Unit shows how many Ethernet hosts they support on their Ethernet port as the “Max Users on
Satellite” parameter.
5) Test Link Quality
Click the Monitor button and the Link Test tab to find out which wireless stations are in range and to check their
link quality.
Note: Link Test requires Internet Explorer version 6.0 or later. Earlier versions do not support Link Test.
Link Test for the unit reports the Signal-to-Noise Ratio (SNR) value; the higher this number, the better the signal
quality. Further, it reports the signal level and noise level in dBm. The latter two are approximations of the level
at which the unit receives the signal of the peer unit and the background noise.
• Explore from a BSU displays all its registered SUs.
• Explore from an SU displays only the BSU with which it is registered.
All stations displayed after “Explore” come up “Disabled.” Select a station by changing Disabled to Start and
click the Link Test button. You can change multiple stations to Start, but only the last station in the list is
displayed as the remote partner when you click the Link Test button. See the following figure: