User's Manual
Table Of Contents
- _
- Chapter 6. Procedures
- Chapter 7. Troubleshooting
- _
- Appendix A. Country Codes/Channels
- Appendix B. Technical Specifications
- _
- Appendix C. Lightning Protection
- Technical Support
- Statement of Warranty
Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 92
default value of -1 in Transparent mode and must be configured with a value in the range of 1 to 4095 to
change the BSU VLAN mode to Trunk mode.
Management VLAN Priority
The Management VLAN priority values range from 0 to 7 and the default priority is 0 (zero).
Relaying Flag
When this flag is enabled, the BSU relays frames between SUs on the same BSU
Add BSU Table Entries
To add entries to the BSU table, click the Add Table Entries button on the BSU Table tab. Enter a VLAN ID and
select a Status, then click Add to add your entry to the table.
Edit or Delete BSU Table Entries
To edit or delete entries in the BSU Table, click the Edit/Delete Table Entries button on the BSU Table tab,
make your changes, then click OK for your changes to take effect.