User's Manual
Table Of Contents
- _
- Chapter 6. Procedures
- Chapter 7. Troubleshooting
- _
- Appendix A. Country Codes/Channels
- Appendix B. Technical Specifications
- _
- Appendix C. Lightning Protection
- Technical Support
- Statement of Warranty
Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 91
BSU in Trunk Mode
BSU VLAN Configuration
The HTTP Interface to configure SU VLAN parameters is shown in the following figure.
The BSU Trunk VLAN Table applies when the BSU is in Trunk mode. The VLAN ID values for the Trunk VLAN
Table range from 1 to 4095; the default value is -1. The maximum number of VLAN IDs that can be configured in
the Trunk VLAN Table for the BSU is 256. An SU in Trunk mode is assigned VLAN IDs from this table.
The following VLAN parameters must be configured for the BSU:
VLAN Mode
The BSU VLAN mode can be either Transparent mode or Trunk mode. By default, the BSU is in
Transparent mode.
Management VLAN ID
The Management VLAN ID applies when the BSU is in Trunk mode. The management VLAN ID has a