User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 80
Add Entries to the Static MAC Filter Table
To add the entries to Filter table, click the Add Table Entries button.
After entering the data, click the Add button. The entry is enabled automatically when saved.
To edit an entry, click Edit. To disable or remove an entry, click Edit and change the Status field from Enable to
Disable or Delete.
Field Descriptions
Wired MAC Address
Enter the MAC address of the device on the Ethernet network that you want to prevent from communicating
with a device on the wireless network.
Wired Mask
Enter the appropriate bit mask to specify the range of MAC addresses to which this filter is to apply. To
specify only the single MAC address you entered in the Wired MAC Address field, enter 00:00:00:00:00:00
(all zeroes).
Wireless MAC Address
Enter the MAC address of the wireless device on the wireless interface that you want to prevent from
communicating with a device on the wired network.
Wireless Mask
Enter the appropriate bit mask to specify the range of MAC addresses to which this filter is to apply. To
specify only the single MAC address you entered in the Wireless MAC Address field, enter 00:00:00:00:00:00
(all zeroes).
Comment
Enter related information.
Status
The Status field can show Enable, Disable, or Delete.