User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 1. Overview 7
Reference Manual
As a companion to the Installation and Management manual, the Tsunami MP.11 Reference Manual provides the
following supplemental information:
Command Line Interface
Documents the text-based configuration utility’s keyboard commands and parameters.
Event Log Error Messages
Documents the error messages that you may see in your Event Log.
Alarm Traps
Documents the traps that can be set for alarm notification.
Microsoft Windows IAS Radius Server Configuration
Provides information to assist you in setting up the IAS Radius Server.
Addition of Units to a Routed Network
Describes how to add more units to your routed network.
Glossary
Describes terms used in the Tsunami MP.11 documentation and in the wireless industry.
If you are already familiar with this type of product, you can use the Quick Install Guide to install the unit.
WIRELESS NETWORK TOPOLOGIES
The unit can be used in various network topologies and combinations. The required equipment depends upon the
wireless network topology you want to build. Make sure all required equipment is available before installing the
unit.
The 5054-R and 2454-R are designed for outdoor placement. One model of the SU is equipped with an
integrated antenna. For all other models, you can connect the unit to an outdoor antenna. See the Tsunami
MP.11 Antenna Installation Guide for details.
WARNING! To connect the unit to an outdoor antenna, consult the appropriate manufacturers’
documentation for additional regulatory information, safety instructions, and installation
requirements.
You can set up the following types of topologies:
• Point-to-Point Link
• Point-to-Multipoint Network
Each unit is set up as either a Base Station Unit (BSU) or a Subscriber Unit (SU). A BSU can, depending upon its
configuration, connect to one or more SUs. An SU, however, can connect only to one BSU. A direct link between
two locations always consists of a BSU and a SU.