User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 57
Enter the Server IP Address and any optional comments; click Add.
Edit/Delete Entries to the DHCP Relay Agent Table
Click Edit/Delete Table Entries to make changes; enter your changes and click OK.
3) Configure Interface Settings
Configure the Wireless Interface
To configure the wireless interface, click the Configure button followed by the Interfaces tab; then click the
Wireless sub-tab.
For Base Station units, the wireless interface can be placed in either WORP Base or WORP Satellite mode
(selected from the Interface Type drop-down box). SUs can be placed only in WORP Satellite mode. The
wireless interface settings depend upon whether the mode is Base or Satellite.
The Wireless Outdoor Router Protocol (WORP) is a polling algorithm designed for wireless outdoor networks.
WORP takes care of the performance degradation incurred by the so-called “hidden-node” problem, which can
occur when wireless LAN technology is used for outdoor building-to-building connectivity. In this situation, when
multiple units send an RTS, if another unit is transmitting, it corrupts all data being sent, degrading overall
performance. The WORP polling algorithm ensures that these collisions cannot occur, which increases the
performance of the overall network significantly.
WORP dynamically adapts to the number of SUs that are active on the network and the amount of data they have
queued to send.
The following are examples of the Wireless window when the country selected is US, and for countries different
than the US: