User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 56
End IP Address
Indicates the ending IP address that is used for assigning address to hosts on the Ethernet side in the
configured subnet.
Default Lease Time
Specifies the default lease time for IP addresses in the address pool. The value is 3600-86400 seconds.
Max Lease Time
The maximum lease time for IP addresses in the address pool. The value is 3600-86400 seconds.
Comment
The comment field is a descriptive field of up to 255 characters.
Edit/Delete Entries to the DHCP Server IP Pool Table Entries
Click Edit/Delete Table Entries to make changes; enter your changes and click OK.
Enable the DHCP Relay Agent (Routing mode only)
Click the Configure button, the Network tab, and the DHCP RA sub-tab to enable the unit’s DHCP Relay Agent.
When enabled, the DHCP relay agent forwards DHCP requests to the set DHCP server.
Note that DHCP Relay Agent parameters are configurable only in Routing mode.
Add Entries to the DHCP Relay Agent Table
To add entries to the table of DHCP Relay Agents, click Add Table Entries; the following window is displayed.