User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 55
Field Descriptions
DHCP Server Status
Verify that DHCP Relay Agent is disabled. After you have made at least one entry in the DHCP server IP Pool
Table, enable DHCP Server by selecting “Enable” from the DHCP Server Status pull-down menu.
Note: There must be at least one entry in the DHCP server IP Pool Table to enable DHCP server. Also,
DHCP server cannot be enabled if DHCP Relay Agent is enabled.
Subnet Mask
The unit supplies this subnet mask in its DHCP response to a DHCP request from an Ethernet host. Indicates
the IP subnet mask assigned to hosts on the Ethernet side using DHCP.
Gateway IP Address
The unit supplies this gateway IP address in the DHCP response. Indicates the IP address of a router
assigned as the default gateway for hosts on the Ethernet side.
Primary DNS IP Address
The unit supplies this primary DNS IP address in the DHCP response. Indicates the IP address of the primary
DNS server that hosts on the Ethernet side uses to resolve Internet host names to IP addresses
Secondary DNS IP Address
The unit supplies this secondary DNS IP address in the DHCP response.
Number of IP Pool Table Entries
The number of IP pool table entries is a read-only field that indicates the total number of entries in the DHCP
server IP Pool Table. See “DHCP Server IP Pool Table”
below.
Add Entries to the DHCP Server IP Pool Table
You can add up to 20 entries in the IP Pool Table. An IP address can be added if the entry’s network ID is the
same as the network ID of the device. To add an entry click Add Table Entries.
Enter the following parameters and click Add.
Note: After adding entries, you must reboot the unit before the values take effect.
Field Descriptions
Start IP Address
Indicates the starting IP address that is used for assigning address to hosts on the Ethernet side in the
configured subnet.