User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 54
SU Screen
Enable or disable the Roaming feature in the Roaming Status drop-down box. The default value is disabled.
Note: To enable roaming, you must enable Roaming Status on both the BSU and the SU.
Enable and Configure the DHCP Server
Click the Configure button, the Network tab and the DHCP Server sub-tab to enable the unit on a DHCP Server.
The Gateway IP Address and Primary DNS IP Address must be entered, there must be at least one entry in the
DHCP Server IP Pool Table, and the DHCP Relay Agent must be disabled, in order to enable the DHCP Server.
When enabled, the DHCP server allows allocation of IP addresses to hosts on the Ethernet side of the SU or
BSU. Specifically, the DHCP Server feature lets the SU or BSU respond to DHCP requests from Ethernet hosts
with the following information:
• Host IP address
• Gateway IP address
• Subnet Mask
• DNS Primary Server IP address
• DNS Secondary Server IP address