User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 47
2) Configure Network Parameters
Change IP Parameters
The IP Configuration window lets you change the IP parameters. These settings differ when the unit is in
Routing mode.
Click the Configure button, the Network tab, and the IP Configuration sub-tab to view and configure local IP
address information. See “Setting the IP Address”
on page 22 for more information.
If the device is configured in Bridge mode, you can set the IP Address Assignment Type parameter:
• Select Static if you want to assign a static IP address to the unit.
• Select Dynamic to have the device run in DHCP client mode, which gets an IP address automatically from a
DHCP server over the network.
If you do not have a DHCP server or if you want to manually configure the IP settings, set this parameter to
Static.
When the unit is in Bridge mode, only one IP address is required. This IP address also can be changed with
ScanTool (see “Setting the IP Address”
on page 22). In Routing mode, both Ethernet and Wireless interfaces
require an IP address.
You can set the following remaining parameters only when the IP Address Assignment Type is set to Static.
IP Address
The unit’s static IP address (default IP address is 10.0.0.1).
Subnet Mask
The mask of the subnet to which the unit is connected (the default subnet mask is 255.255.255.0).
Default Router IP Address
The IP address of the default gateway.
Default TTL
The default time-to-live value.