User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 46
Notes:
• One of the most important details to pay attention to in Routing mode are the unit’s and the PC’s default
gateways. It is a common mistake to set up the PC’s gateway to point to the SU when the SU is in Bridge
mode and the BSU is in Routing mode. Always check to make sure the PCs on your network are configured
to send their IP traffic to the correct default gateway.
• Be sure to reboot the unit to permanently save static routes. New routes take effect immediately without a
reboot, but are not permanently saved with your configuration until you do reboot the device. An unexpected
power outage could cause static routes you entered to “disappear” when the unit reboots if they have not
been saved. You also should save a copy of your unit’s configuration file in case the unit must be reloaded.
This saves you from being required to re-enter numerous static routes in a large network.
• The routing table supports up to 500 static routes.