User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 42
CONFIGURE THE UNIT’S SETTINGS
Use the Configure section to change the unit’s settings. The following tabs are in this section:
1. System Parameters
below
2. Network Parameters
on page 47
3. Interfaces
on page 57
4. SNMP
on page 67
5. RIP
on page 67
6. Management
on page 70
7. Security
on page 73
8. Filtering
on page 75
9. Intra-Cell Blocking
on page 85 (for BSUs in Bridge mode only)
10. VLAN (Virtual Local Area Network)
on page 88 (for BSUs in Bridge mode only)
11. QoS (Quality of Service)
on page 96 (for BSUs only)
12. NAT (Network Address Translation)
on page 98 (for SUs in Routing mode only)
1) Configure System Parameters
The System configuration page lets you change the unit’s System Name, Location, and so on. These details
help you to distinguish the unit from other routers and let you know whom to contact in case you experience
problems.
Click the Configure button and the System tab; the following window is displayed.
In this window, you can view or change the basic system information. Mode of Operation sets the unit as bridge
(layer 2) or as router (layer 3). See “Bridge and Routing Modes”
on page 44 for more information.