User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 5. Using the Web Interface 40
Chapter 5. Using the Web Interface
This section covers the unit’s Web Interface. The interface is described hierarchically according to these buttons,
which appear on the left side of the Web page:
• System Status
below
• Configure
on page 42
• Monitor
on page 108
• Commands
on page 116
Help and Exit buttons also appear; click the Help button to access online help; click the Exit button to exit the
application.
For an introduction to the basics of management, see “Chapter 4. Basic Management”
on page 33.
SYSTEM STATUS
When you click the Status button, System Status is displayed automatically. The other tab under Status is the
Event Log tab.
View System Status
The Status tab showing the system status is displayed automatically when you log into the Web Interface. It also
is the default window displayed when you click the Status button on the left side of the window.
The Status tab shows the System Status and the System Traps.
System Status
The basic system status is shown in this section, including the version number of the embedded software.
Systems Traps
The status of system traps is shown in this section. System traps occur when the unit encounters
irregularities. Deleting system traps has no effect on the operation of the unit. System traps also are sent to
an SNMP manager station (if so configured). See “Alarm Traps” in the Tsunami MP.11 Reference Manual for
a list and description of the traps.