User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 3. Management Overview 25
CHANGING BASIC CONFIGURATION INFORMATION
To view or change basic system information, click the Configure button on the left side of the Web interface
window, then click the System tab. See “Configure System Parameters”
on page 42 for detailed information
about the fields and selections in this window.
Note: System Name by default contains the actual model number. The following screenshot is for information
only.
Country and Related Settings
The unit’s Configure System window provides a selectable Country field that automatically provides the allowed
bandwidth and frequencies for the selected country.
Units sold in the United States are pre-configured to scan and display only the outdoor frequencies permitted by
the FCC. No other Country can be configured. Units sold outside of the United States support the selection of a
Country by the professional installer.
Note: Non-US installers should not add an antenna system until the Country is selected, the unit is rebooted,
and the proper power level is configured. The output power level of the final channel selected by DFS
scan can be found in the Event Log (see “Event Log”
on page 41).
The Dynamic Frequency Selection (DFS) feature is enabled automatically when you choose a country with a
regulatory domain that requires it. The Transmit Power Control (TPC) feature is always available.
Click the Configure button and the System tab; then select the appropriate country for your regulatory domain
from the Country drop-down box.
Continue configuring settings as desired; then click the Commands button and the Reboot tab to save and
activate the settings. Alternatively, if you want to save the configuration settings to the flash memory but not
activate the settings, use the save config CLI command.