User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 2. Installation 16
GREEN Power is on and the Ethernet link is up.
RF (Wireless) Link
RED Power is on, unit is self-heating
BLINKING GREEN
A wireless link is being established.
GREEN A wireless link has been established.
Note: The two LEDs also are continually blinking if there is any serious initialization error or when Ethernet and
wireless connections both are not active. If the Ethernet is connected to a hub, check the powering of the
hub and the Ethernet cable type (crossover, straight-through). If the peer unit is operational, check the
configuration of the units.
6) INSTALLING DOCUMENTATION AND SOFTWARE
The CD contains the following documentation and software:
Online help
This is the help for the Web Interface. It is also stored on your computer or network during the installation
process, so it is always available (see c:\Program Files\Tsunami\MP.11). You can also find the help in the
Docs folder of the product CD.
Documentation
Documentation is provided in PDF format, including:
º Release Notes
º Tsunami MP.11 2454-R and 5054-R Quick Install Guide
º Tsunami MP.11 2454-R and 5054-R Installation and Management
º Tsunami MP.11 Reference Manual
º Tsunami MP.11 Antenna Installation
º Tsunami MP.11 Recommended 5 GHz and 2.4 GHz Antennas
º Safety and Regulatory Information
. You can find this documentation in the Docs folder of the product CD. This documentation also is installed at
c:\Program Files\Tsunami\MP.11.
ScanTool
ScanTool lets you find the IP address of a Tsunami MP.11 5054-R or 2454-R by referencing the MAC
address in a Scan List, or to assign an IP address if one has not been assigned. The tool automatically
detects the units installed on your network, regardless of IP address, and lets you configure each unit’s IP
settings. In addition, you can use ScanTool to download new software to a unit that does not have a valid
software image installed. See “Setting the IP Address Manually”
on page 22 for details. You can find
ScanTool in the Xtras directory of the product CD. It is installed at c:\Program Files\Tsunami\MP.11.
TFTP Server
The TFTP (Trivial File Transfer Protocol) server lets you transfer files across the network. You can download
configuration files, as well as image files for embedded software upgrades, and you can upload files from the
unit for backup. Here downloading means transferring files to the unit and uploading means transferring files
in the opposite direction. See “TFTP Server Setup”
on page 119, “Download “ on page 116, and “Upload” on
page 117 for more information. You can find the TFTP Server in the Xtras directory of the product CD. It is
installed at c:\Program Files\Tsunami\MP.11.