User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 2. Installation 12
2) PRE-ASSEMBLE THE HARDWARE
Before mounting the unit, note the Ethernet and Mac addresses of the SU, as well as the serial number; these
addresses may be used when configuring the BSU. The serial number is required to obtain support from Proxim.
Keep this information in a safe place.
The units are designed to directly mount to a pole. Using the supplied brackets and hardware, you can mount
them to a 1.25 inch to 4.5-inch pole (outside diameter). Using just one of the pole mounting brackets, you can
mount the units to a wall or other flat surface.
Note: Equipment is to be used with, and powered by, the power injector provided or by a power injector that
meets the following requirements:
• UL-Listed/ITE (NWGQ)
• Limited Power Source Output per UL/IEC 60950
• CE-marked
• Approved for Power-over-Ethernet,
• Rated output, 48 Vdc/0.42 A
• Wired according to the 802.3af standard for mid-span devices
To install the unit:
1. Unpack the unit and accessories from the shipping box.
2. You will be attaching an outdoor-rated Cat5e cable (not provided) to the Power-over-Ethernet port on the
back of the unit later in the installation procedure. First, you must construct the cable and assemble the
Liquid-Tite cable covers as described in the following steps:
a. Slide the plastic nut over the bare end of the Cat5e cable.
b. Attach the Heyco cable seal to the RJ45 sealing cap. Finger tighten, and slide these two assembled parts
over the bare end of the Cat5e cable.
c. Terminate the RJ45 connector to the Cat5e cable. Insert into the mating RJ45 connector.
d. Slide the RJ45 sealing cap assembly over the RJ45 connector and thread onto enclosure. Hand tighten.
e. Thread the plastic nut onto Heyco seal, and hand tighten.
Caution! The domed sealing nut (item “a” above) of the Liquid-Tite connector must not be tightened
until the cap over the RJ45 connector has been tightened to the unit during final installation;
otherwise, the Ethernet cable may twist and damage.