User's Manual

Tsunami MP.11 2454-R, 5054-R, and 5054-R-LR Installation and Management
Chapter 2. Installation 10
Chapter 2. Installation
This chapter describes the steps required to install and mount the unit, and to align the antenna. An antenna
cable is required only when you use the external antenna option. Note that the unit must have either the
integrated antenna or must be connected to an external antenna for its operation. The installation procedure does
not include the mounting and connection of antennas. See the Tsunami MP.11 Antenna Installation Guide for this
information.
If you are already familiar with this type of product, you can use the Quick Install Guide for streamlined installation
procedures.
The 5054-R and 2454-R units contain a state-of-the-art wireless radio, an optional high-gain performance flat-
panel antenna, and Power-over-Ethernet (the sole means of power for the unit). For further protection, the unit
has internal, built-in surge protection.
IMPORTANT!
Before installing this product, see “Safety and Regulatory Information” on the product CD for important
safety and regulatory compliance information.
WARNING
To ensure proper grounding, use the hole at the bottom point on the back of each unit and the provided
grounding screws to attach a ground wire of at least 10 AWG stranded to each unit. Use proper wire
grounding techniques in accordance with National Electric Codes (NEC).
1) VERIFY PACKAGE CONTENTS
Each Tsunami MP.11 5054-R or 2454-R shipment includes the items in the table as well as the mounting
hardware listed on the following page. Verify that you have received all parts of the shipment.
SU with Integrated Antenna or
BSU / SU with external antenna
connector
RJ11 to DB9 serial connector
(supplied with BSU only)
(1 ea.)
Installation CD (1 ea.)
Power Injector and Cord (1 ea.)
Cable Termination Kit
(1 ea.)
RJ45
Connector
Weather-tight
connector cap
Liquid-Tite
Fitting
Grounding
Screw