User's Manual

Federal Communications Commission (FCC) Compliance

This device operates at 5.25 - 5.35 GHz, and 5.75 - 5.85 in compliance with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: 1) this device may not cause harmful interference,

and 2) this device must accept any interference received, including interference that may cause

undesired operation.

To comply with the FCC radio frequency exposure requirements, the following antenna installation and

device operating configurations must be satisfied:

• Product models using external antennas require professional installation. The antennas used for

professional installation must be fixed-mounted on indoor/outdoor permanent structures with a

separation distance of at least 100 cm from all persons.

• Antennas must not be co-located and must not operate in conjunction with any other antenna or

transmitter.

Modifications

Changes or modifications to this device that are not expressly approved by the manufacturer of the

product could void the user’s authority to operate the equipment.

Warnings

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection again

harmful interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try

and correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help