User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Technical Specifications MP.11 4954-R Installation and Management
Security
164
Base Station Unit
• Filtering
– Intra Cell Blocking
Subscriber Units
• Services
– NAT (RFC 3022)
– DHCP Relay (RFC 2131)
Security
• WORP provides critical feature support for secure long-range wireless deployments in unlicensed frequency
spectrum.
• MD5 (embedded in WORP) authentication between BSU and SU.
• Filter based on packet information such as unicast/multicast/ broadcast MAC or IP.
• Secure “over the air encryption” with WEP, WEP+, and AES, and AES-CCB.
• Authentication via Radius
• Intracell blocking allows the BSU to act as the central policy enforcer for SU to SU communications.
Management
• SU/BSU statistics
•Link Test
• Temperature logging
• SNMP v1/v2 (RFC 1157)
• SNMP v2c (RFC 1907)
• HTTP Server (RFC 2616)
• Telnet (RFC 855)
• TFTP client (RFC 783)
•CLI
• MIB-II (RFC 1213)
• Ethernet-like MIB (RFC 1643)
• Bridge MIB (RFC 1493)
• 802.3MAU (RFC 2668)
• 802.11 MIB
• Remote reboot (reload) or reset to factory default via power injector
• Private MIB
• Orinoco MIB
Antenna
• Audible tone
• CLI output