User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Configuration MP.11 4954-R Installation and Management
VLAN Parameters
103
The following parameters are configurable:
• BSU VLAN Mode: The BSU VLAN mode can be either Transparent or Trunk. By default, the BSU is in Transparent
mode.
• Management VLAN ID: The Management VLAN ID is configurable in any mode. The management VLAN ID has a
default value of untagged and may be configured with a value in the range of 1 to 4095.
• Management VLAN Priority: The Management VLAN priority values range from 0 to 7 and the default priority is 0
(zero).
• Relaying Flag: When this flag is enabled, the BSU relays frames between SUs on the same BSU.
• BSU VLAN Table: The BSU VLAN Table is configurable in both Transparent and Trunk mode, but applies only when
the BSU is in Trunk mode. The VLAN ID values for the BSU VLAN Table range from 1 to 4095. The maximum number
of VLAN IDs that can be configured in the BSU VLAN Table is 256. An SU in Trunk mode is assigned VLAN IDs from
this table.
Add BSU VLAN Table Entries
To add entries to the BSU VLAN table, click the Add Table Entries button. Enter a VLAN ID and select a Status, then
click Add to add your entry to the table.
Edit or Delete BSU VLAN Table Entries
To edit or delete entries in the BSU VLAN Table, click the Edit/Delete Table Entries button, make your changes, then
click OK for your changes to take effect.