User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Procedures MP.11 4954-R Installation and Management
Soft Reset to Factory Default
144
Soft Reset to Factory Default
If necessary, you can reset the unit to the factory default settings. Resetting to default settings means that you must
configure the unit anew.
To reset to factory default settings using the Web Interface:
1. Click Commands > Reset.
2. Click the Reset to Factory Default button.
The device configuration parameter values are reset to their factory default values.
If you do not have access to the unit, you can use the procedure described in “Hard Reset to Factory Default” below as
an alternative.