User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Procedures MP.11 4954-R Installation and Management
Web Interface Image File Download
141
Web Interface Image File Download
In some cases, it may be necessary to upgrade the embedded software of the unit by downloading an image file. To
download an image file through the Web Interface:
1. Set up the TFTP server as described in TFTP Server Setup.
2. Access the unit as described in Logging in to the Web Interface.
3. Click Commands > Download tab.
4. Fill in the following details:
• Server IP Address <IP address TFTP server>
• File Name <image file name>
• File Type Image
• File Operation Download
5. Click OK to start the file transfer.
The unit downloads the image file. The TFTP server program should show download activity after a few seconds. When
the download is complete, the unit is ready to start the embedded software upon reboot.