User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Commands MP.11 4954-R Installation and Management
Reset the Unit to Factory Default
136
Reset the Unit to Factory Default
Click Commands > Reset to restore the configuration of the unit to the factory default values.
You can also reset the unit by pressing the RELOAD button located on the side of the power brick. See Hard Reset to
Factory Default for more information.
CAUTION: Resetting the unit to its factory default configuration permanently overwrites all changes made to the unit.
The unit reboots automatically after this command has been issued.