User's Manual
Table Of Contents
- Monitoring
- Commands
- Procedures
- Troubleshooting
- Frequency Bands and Channels
- Technical Specifications
- Part Numbers
- Regulatory Approvals and Frequency Ranges
- Integrated Antenna Specifications
- RF Modulation and Over-the-Air Rates
- Wireless Protocol
- Device Interface
- Network Architecture Type
- Receive Sensitivity
- Maximum Throughput
- Latency
- Transmit Power Settings
- Range Information
- System Processor and Memory
- Software Specification
- Security
- Management
- Antenna
- Status LEDs
- Local Configuration Support
- Compliance and Standards
- Electrical
- Dimensions
- Subscriber Unit with Integrated 21-dBi Antenna Unpackaged: 12.60 in x 12.60 in x 3.50 in (320 mm x 320 mm x 18 mm) Weight
- Environmental
- Packaging Contents
- MTBF
- Warranty
- Lightning Protection
- Technical Services and Support
- Statement of Warranty
Configuration MP.11 4954-R Installation and Management
QoS (Quality of Service) Parameters
110
• SF Entry State: This field can be set to Enable, Disable, or Delete.
Click Add to add the entry. The new entry will appear on the screen, taking up the next sequential index entry.
To make changes to the entries of the SFC Table, click the Edit/Delete Table Entries button.
Enter your changes and click OK. To delete an entry, click the Status drop-down box and select Delete, then click OK.
QoS Class Configuration
Click Configure > QoS > QoS Class. The 4 predefined QoS classes are shown.
To view/edit a QoS Class click on its Details button. You may enable, disable or delete this QoS Class entry by clicking
on the Status drop-down box and then clicking OK. You may also edit an existing SFC associated to this QoS class, or
add a new SFC.
No. of messages in a burst: % of the maximum throughput:
4 100%
3 97.6%
2 92.9%
1 76.2%