User`s guide

Wireless > Wi-Fi The LAN-Cell’s integrated 802.11 a/b/g access point is

DISABLED by default. Use the screens in this area to

enable and configure your Wi-Fi settings.

Security > Firewall You can use the LAN-Cell without configuring the

firewall. The LAN-Cell’s firewall is ENABLED by default

and is set to block inbound initiated packets to LAN

devices. You may need to change the default firewall

rules to suit your specific application.

Security > VPN The LAN-Cell 2 includes a Wizard to step you through

the process of creating a basic IPSec VPN. Use the

VPN Config screens to adjust any settings as

necessary for connection to your other VPN equipment.

Advanced > DNS Use the DDNS tab to configure a DNS hostname for

your LAN-Cell if your Cellular or WAN ISP assigns

dynamic IP addresses. You must set up an account with

one of the supported Dynamic DNS Service Providers

before configuring the LAN-Cell.

Advanced > NAT To access devices attached to the LAN-Cell’s LAN ports

from the Internet, configure the necessary port

translation/redirections on this screen. You may also

need to change the LAN-Cell’s Remote Management

ports and VPN Rules if they conflict with your

application.

Maint > Time & Date The LAN-Cell 2 has a battery-backed real-time clock.

Set the current date & time on this screen and configure

a time-server to periodically adjust the LAN-Cell’s clock.

Consult the User’s Guide for more detailed information on how to configure

all of the LAN-Cell’s features.

Note for Wi-Fi Users:

If deploying the LAN-Cell 2 outside of North America, you must

change the

firmware’s Country Code to enable the appropriate 802.11 channels for the

country of operation. Failure to change the Country Code may cause

unintended interference or prevent other 802.11 equipment from connecting

to the LAN-Cell and may violate local communication regulations. See the

Wireless LAN section of the User’s Guide for more information.

Once the LAN-Cell is functioning to your satisfaction, we strongly

recommend that you backup the device configuration to your PC.

See: Maintenance > Backup & Restore