User`s guide

III. LAN-Cell 2 Default Settings
The factory default settings for the LAN-Cell’s key parameters are:
LAN-Cell’s LAN IP Address 192.168.1.1
Management Access Password 1234
TCP Management Ports HTTP (80), HTTPS (443),
Telnet (23), SSH (22)
LAN DHCP Server On
LAN DHCP Settings 192.168.1.33 to .160
Subnet mask 255.255.255.0
WAN DHCP Client On
Cellular Modem Interface Enabled, Dial on Demand, Cell-Sentry Off
WLAN Access Point Disabled
WLAN Country Code 255 – U.S. / North America
Firewall Enabled
Serial Console Port 9600 bps, no parity, 8 data bits, 1 stop bit,
no flow control.
Press the Reset button for 10 seconds to return the LAN-Cell to these settings.
IV. Using the Internal Web Configurator
NOTE: You can use either the embedded web configurator or the System
Management Terminal to access and configure the LAN-Cell. This Quick Start
Guide shows you how to use the web configurator only. See the User’s Guide
for more information on all of the LAN-Cell’s configuration options.
Click the web configurator’s help icon
for screen-specific assistance.
Step 1: Enter http://192.168.1.1 as the web site address in your browser.
Step 2: The default password (“1234”) is already in the password field (in non-
readable format). Click Login to proceed to the Change Password screen.
Step 3: It is highly recommended that you change the default password! Enter
a new password, retype it to confirm and click Apply. The LAN-Cell will then
request that you log in again. Alternatively, click Ignore to proceed if you do not
want to change the password.
Step 4: Click OK to create a unique security certificate for this LAN-Cell or click
Ignore to later import your own certificate.
Step 5: You should now see the LAN-Cell’s Home (System Status) screen
(see Figure 4).
4