User`s guide

Troubleshooting
PROBLEM CORRECTIVE ACTION
None of the
LEDs turn on
Ensure that the correct power adapter is connected to the
LAN-Cell and have plugged it into an appropriate power
source. If the LEDs still do not turn on, there may be a
hardware problem – contact your vendor.
Cannot access
the LAN-Cell
from a PC on
the LAN
Check the cable connection between your computer (or
hub) and the LAN-Cell. Check that the corresponding
LAN port LED is ON.
Confirm that your PC’s default gateway is the LAN-Cell’s
IP address.
Confirm that any other network interfaces on the PC (such
as Wi-Fi) are disabled. You cannot use Wi-Fi for the initial
configuration of the LAN-Cell, as the internal Wi-Fi Access
Point is disabled by default.
Configure your PC to receive its IP settings via DHCP.
Cannot ping any
computer on the
LAN
If the LAN LEDs are off, check the cable connections.
Verify that the IP address and subnet of the LAN-Cell is in
the same range as the computers on the LAN and that the
LAN-Cell is the default gateway for all LAN devices.
Cellular modem
card does not
initialize
(Cell LED
continues to
flash)
Confirm that the PC-Card modem has been activated by
your cellular carrier. Follow their instructions for activating
the card using a Windows PC.
If your cellular modem card requires a SIM/RUIM card,
ensure that it is properly inserted.
Network registration may take several minutes.
Confirm that your 3G cellular modem card is supported by
the LAN-Cell’s firmware version (see the Release Notes).
12