User`s guide

Chapter 4 LAN Screens

LAN-Cell 2 User’s Guide

4.3 LAN Static DHCP Screen

This table allows you to assign IP addresses on the LAN to specific individual computers

based on their MAC Addresses.

To change your LAN-Cell’s static DHCP settings, click NETWORK > LAN > Static DHCP.

The screen appears as shown.

Allow between

LAN and Cellular

Select this check box to forward NetBIOS packets from the LAN to CELL and from

CELL to the LAN. If your firewall is enabled with the default policy set to block

CELL to LAN traffic, you also need to enable the default CELL to LAN firewall rule

that forwards NetBIOS traffic.

Clear this check box to block all NetBIOS packets going from the LAN to CELL and

from CELL to the LAN.

Allow between

LAN and DMZ

Select this check box to forward NetBIOS packets from the LAN to the DMZ and

from the DMZ to the LAN. If your firewall is enabled with the default policy set to

block DMZ to LAN traffic, you also need to enable the default DMZ to LAN firewall

rule that forwards NetBIOS traffic.

Clear this check box to block all NetBIOS packets going from the LAN to the DMZ

and from the DMZ to the LAN.

Allow between

LAN and WLAN

Select this check box to forward NetBIOS packets from the LAN to the WLAN and

from the WLAN to the LAN.

Clear this check box to block all NetBIOS packets going from the LAN to the WLAN

and from the WLAN to the LAN.

Apply Click Apply to save your changes back to the LAN-Cell.

Reset Click Reset to begin configuring this screen afresh.

Table 15 NETWORK > LAN (continued)

LABEL DESCRIPTION