User`s guide

Chapter 3 Tutorials: 3G Modem Setup & VPN Wizard
LAN-Cell 2 User’s Guide
58
3.2.2 VPN Wizard Network Setting
Use this screen to name the VPN network policy (IPSec SA) and identify the devices behind
the IPSec routers at either end of a VPN tunnel.
Two active SAs cannot have the local and remote IP address(es) both the same. Two active
SAs can have the same local or remote IP address, but not both. You can configure multiple
SAs between the same local and remote IP addresses, as long as only one is active at any time.
Figure 26 VPN Wizard: Network Setting
The following table describes the labels in this screen.
Remote
Gateway
Address
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by its IP address or a
domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN
IP address.
Back Click Back to return to the previous screen.
Next Click Next to continue.
Table 10 VPN Wizard: Gateway Setting
LABEL DESCRIPTION
Table 11 VPN Wizard: Network Setting
LABEL DESCRIPTION
Network Policy
Property
Active If the Active check box is selected, packets for the tunnel trigger the LAN-Cell to build
the tunnel.
Clear the Active check box to turn the network policy off. The LAN-Cell does not
apply the policy. Packets for the tunnel do not trigger the tunnel.
Name Type up to 32 characters to identify this VPN network policy. You may use any
character, including spaces, but the LAN-Cell drops trailing spaces.
Network Policy
Setting