User`s guide

Chapter 43 Troubleshooting
LAN-Cell 2 User’s Guide
570
4 Turn the LAN-Cell off and on or disconnect and re-connect the power adaptor to the
LAN-Cell.
5 If the problem continues, contact the vendor.
43.2 LAN-Cell Access and Login
V I forgot the LAN IP address for the LAN-Cell.
1 The default LAN IP address is 192.168.1.1.
2 Use the console port to log in to the LAN-Cell.
3 If you changed the IP address and have forgotten it, you might get the IP address of the
LAN-Cell by looking up the IP address of the default gateway for your computer. To do
this in most Windows computers, click Start > Run, enter cmd, and then enter ipconfig.
The IP address of the Default Gateway might be the IP address of the LAN-Cell (it
depends on the network), so enter this IP address in your Internet browser.
4 If this does not work, you have to reset the device to its factory defaults. See Section 2.4
on page 51.
V I forgot the password.
1 The default password is 1234.
2 If this does not work, you have to reset the device to its factory defaults. See Section 2.4
on page 51.
V I cannot see or access the Login screen in the web configurator.
1 Make sure you are using the correct IP address.
• The default LAN IP address is 192.168.1.1.
• Use the LAN-Cell’s LAN IP address when configuring from the LAN.
• Use the LAN-Cell’s WAN IP address when configuring from the WAN.
• If you changed the LAN IP address (Section 4.2 on page 80), use the new IP address.
• If you changed the LAN IP address and have forgotten it, see the troubleshooting
suggestions for I forgot the LAN IP address for the LAN-Cell.
2 Enter “HTTP://192.168.1.1” (or the current LAN IP address of the LAN-Cell) into your
browsers address bar.
3 Check the hardware connections, and make sure the LEDs are behaving as expected. See
the Quick Start Guide and Section 1.5 on page 30.