User`s guide

Chapter 37 System Information & Diagnosis
LAN-Cell 2 User’s Guide
518
3 There are three commands in Menu 24.1 - System Maintenance - Status. Entering 1 or
2 drops the WAN or CELL connection, 9 resets the counters and [ESC] takes you back
to the previous screen.
Figure 336 Menu 24.1: System Maintenance: Status
The following table describes the fields present in Menu 24.1 - System Maintenance -
Status. These fields are READ-ONLY and meant for diagnostic purposes. The upper right
corner of the screen shows the time and date according to the format you set in menu 24.10.
Menu 24.1 - System Maintenance - Status 03:13:41
Wed. Dec. 06, 2006
Port Status TxPkts RxPkts Cols Tx B/s Rx B/s Up Time
WAN 100M/Full 5863 17802 0 0 128 1:31:14
CELL Down 0 0 0 0 0 0:00:00
LAN 100M/Full 7443 9261 0 370 128 1:31:57
WCRD Down 1 0 0 0 0 0:00:00
DMZ 100M/Full 0 0 0 0 0 1:31:57
WLAN 100M/Full 0 0 0 0 0 1:31:57
Port Ethernet Address IP Address IP Mask DHCP
WAN 00:13:49:00:00:02 172.23.37.10 255.255.255.0 Client
CELL 00:00:00:00:00:00 0.0.0.0 0.0.0.0 None
LAN 00:13:49:00:00:01 192.168.1.1 255.255.255.0 Server
WLAN 00:13:49:00:00:04 0.0.0.0 0.0.0.0 None
DMZ 00:13:49:00:00:03 0.0.0.0 0.0.0.0 None
System up Time: 1:32:02
Wi-Fi bridged to: LAN
Press Command:
COMMANDS: 1, 2-Drop WAN,CELL 9-Reset Counters ESC-Exit
Table 214 System Maintenance: Status Menu Fields
FIELD DESCRIPTION
Port This field identifies an interface (WAN, CELL, LAN, WCRD (internal Wi-Fi AP),
DMZ or WLAN) on the LAN-Cell.
Status For the LAN, DMZ, and WLAN Interfaces, this displays the port speed and duplex
setting.
For the WAN interfaces, it displays the port speed and duplex setting if you’re
using Ethernet encapsulation or the remote node name (configured through the
SMT) for a PPP connection and Down (line is down or not connected), Idle (line
(ppp) idle), Dial (starting to trigger a call) or Drop (dropping a call) if you’re using
PPPoE encapsulation.
For the Wi-Fi AP, it displays the transmission rate when WLAN is enabled or
Down when WLAN is disabled.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
Cols This is the number of collisions on this port.
Tx B/s This field shows the transmission speed in Bytes per second on this port.
Rx B/s This field shows the reception speed in Bytes per second on this port.
Up Time This is the total amount of time the line has been up.