User`s guide

Chapter 2 Introducing the Web Configurator & Home Screen

LAN-Cell 2 User’s Guide

2.4 Resetting the LAN-Cell

If you forget your password or cannot access the web configurator, you will need to reload the

factory-default configuration file or use the RESET button on the back of the LAN-Cell.

Uploading this configuration file replaces the current configuration file with the factory-

default configuration file. This means that you will lose all configurations that you had

previously and the speed of the console port will be reset to the default of 9600bps with 8 data

bit, no parity, one stop bit and flow control set to none. The password will be reset to 1234,

also.

Make sure the SYS LED is on (not blinking) before you begin this procedure.

1 Press the RESET button for ten seconds, and then release it. If the SYS LED begins to

blink, the defaults have been restored and the LAN-Cell restarts. Otherwise, go to step 2.

2 Turn the LAN-Cell off.

3 While pressing the RESET button, turn the LAN-Cell on.

4 Continue to hold the RESET button. The SYS LED will begin to blink and flicker very

quickly after about 20 seconds. This indicates that the defaults have been restored and

the LAN-Cell is now restarting.

Release the RESET button and wait for the LAN-Cell to finish restarting.